4/18/2023 0 Comments Draftsight will not activateThe Line of 2.0 of length is vertical, meaning it forms 90 degrees with the zero degree angle. That being said, if we want to draw the figure above, to find the inclination angle of the oblique line from the zero degree angle, we will do 90-49 which is 41 degrees. Do you remember the trigonometric circle? it comes all down to the same thing.īy default, the zero angle is the same with the zero Angle on a trigonometric circle. There is a 0 degree angle reference in Draftsight, and you are free to set it to be wherever you want. How do you get this done in Draftsight? 1. The main thing to remember is that online activation is not possible if you are using SOLIDWORKS below version 2018 SP 3.On the figure above, we have two lines of length 2.0 and 4.6 and the angle between them is 49 degrees. You can read more about online license here and here If you switch between a laptop for travel and a desktop computer at work, you might benefit from using Online license, introduced in 2018. If you have two versions of SOLIDWORKS installed you must deactivate the newest version first. This message only appears when you try do deactivate your SOLIDWORKS License. If you receive this error message, please contact your VAR as they need contact SOLIDWORKS to have the number of transfers increased. The deactivation count is, for standalone licenses, 999 as a default to ensure that the license is not misused. Usually this message appears when deactivating your license. This error message means that you have exceeded the standard number of transfers of your license. Your VAR har usually requested this if you have not been able to deactivate it yourself. If SOLIDWORKS disabled your license manually this error message will appear. ![]() To have your VAR deactivate your license should only be done as a last resort, as you will not be able to activate the license on the computer again. If your old computer has crashed, and you have no way of opening your old SOLIDWORKS, you should also contact your VAR and they will be able to help you deactivate your license. If you find yourself in a situation where you are unsure what computer the license is active on, please contact your VAR, and they should be able to help you. In order to remedy this, start your SOLIDWORKS on your old machine, go to “Help”-> “Deactivate License”, and follow the onscreen instructions. But the license has not been deactivated on the old machine. Usually the scenario is that the user has gotten a new PC and has installed SOLIDWORKS on this machine. This is by far the most common error message I receive when working in support. I have also included what you can do yourself and if you need to contact your VAR. In the below section I have listed the most common errors when deactivating or activating your SOLIDWORKS license. While working with SOLIDWORKS support, I have received a lot of phone calls regarding activation errors. If you do this it becomes much easier to identify the issue, if you need to contact your SOLIDWORKS Value Added Reseller (VAR). When the activation error message it is important that you take note of the error message or take a screenshot. ![]() However sometimes you will receive an error message. In most cases this goes fine without a hitch. To make it easier to identify and troubleshoot if an activation issue occurs.To ensure that no one is misusing your license.The Activation Manager registers the computer for two reasons: Your computer communicates with the SOLIDWORKS Activation manager when activating and deactivating the SOLIDWORKS license. I will in a later blog post cover the activation and license errors when using SolidNetwork License (SNL) What is standalone activation I will briefly try to go through the four most common activation error messages when using a standalone license. This is the first blog post regarding the SOLIDWORKS activation error message.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |